Installation Instructions - Blodgett KLT-100E Installation Operation & Maintenance

INSTALLATION AND SERVICE CONNECTIONS

2.0 INSTALLATION INSTRUCTIONS

UNPACKING
Immediately after unpacking, check for possible shipping damage. If the kettle is found
to be damaged, save the packaging material and contact the carrier within 15 days of
delivery.
Before installing, verify that the electrical service agrees with the specifications on the
rating plate located on the right side of the tilt console. If the supply and equipment
requirements do not agree, contact your dealer.
Select a location with drainage directly below the tangent draw-off. Allow sufficient rear
clearance from wall for kettle cover to lift upright freely and completely without
obstructions.
1. The kettle must be installed in accordance with:
2. State and/or local codes.
3. In the USA, the National Electrical code, ANSI/NFPA-70 (latest edition). In Canada,
the Canadian Electrical Code, Part 1, CSA Standard C22.1 (latest edition).
4. Set the kettle in the installation location.
5. With the kettle in the upright position, place a carpenter's level on top of the kettle
and turn the adjustable feet to level kettle side-to-side and front to back.
6. Mark hole locations on floor through anchoring holes provided in flanged adjustable
feet.
7. Remove kettle and drill holes in locations marked on the floor (see installation
diagram). Insert proper anchoring devices to accommodate 5/16" size lag bolts (not
supplied).
8. Reposition kettle. Re-level kettle by making necessary adjustments on flanged feet.
9. Bolt down kettle and seal with Silastic or other equivalent sealing compound.
Sealant must be applied not only to bolt heads but also around flanges or pedestal
base making contact with floor surface to fulfill NSF requirements. Wipe off excess
sealant immediately.
WARNING: Disconnect the electrical power supply and place a tag
at the disconnect switch to indicate that you are working on the
circuit.
INSTALLATION
5