Blodgett KLT-100E Installation Operation & Maintenance page 12

DRAW-OFF VALVE CLEANING
1. If equipped with a tangent draw-off valve, turn the large hex nut on the draw-off valve
counterclockwise until it is completely disengaged from the threads. Grasp the valve
knob and slowly pull out the valve stem. Wash the valve stem, disk and handle.
Insert a nylon brush, wet with detergent and water, into the valve body and tangent
draw-off tube. Brush vigorously.
2. Replace the valve stem assembly and turn the hex nut until snug. Rinse the kettle
with clean warm water.
3. Leave the draw-off valve open when the kettle is not in use.
DAIRY DRAW-OFF VALVE CLEANING
1. Remove the plug by first removing the handle, then turn the plug to line up with the
pin and pull with both hands. It is important to use both hands because the plug is
heavy.
2. Put the plug in a plastic pail that contains a mild soap solution. A plastic pail works
best, as it reduces the possibility of nicking or scratching the plug. If the plug gets
scratched it may not seal correctly and could leak.
3. Use a soft cloth or soft brush and clean all surfaces.
4. Using both hands remove the valve from the soap and rinse well in another plastic
pail that contains fresh water.
5. Wash out the kettle as normal.
6. Return the plug into the body. Be sure the plug is inserted into the notch and turned.
Ensure the plug is tight and secure before letting go of it.
If you are cleaning a body and plug assembly, remove the plug and follow the above
procedures. when finished with the plug, follow the same instructions for washing the
body. Always use both hands when handling the plugs. Reassemble the plug into the
body and use as normal.
WHAT TO DO IF SURFACE RUST APPEARS
Metal utensils should never be used as they will scratch the surface of the equipment
and rust may begin to form. To remove surface accumulation of rust from the
inadvertent use of such utensils, the following procedure may be used.
CAUTION: Improper use of this procedure may damage your
appliance!
12