Advertisement
8.
Position Plywood so it sits almost flush with outside of floor joist framing (see Note). When correctly
positioned, attach to all floor joists with approximately 24 - 1 1/4" Screws. Use screws every 16".
B. Wall Section
Top Triangular
Siding Pcs (2) (L/R)
Angled Wall
Extendors (2)
Solid Wall
Panels (4)
See Page 31 for
Optional End Door
Configuration.
Wall Plates (4)
9.
Locate 4 Solid Wall Panels and 4 Wall Plates (1 1/2" x 2 1/2" x 45 1/2"). Attach Plates to
bottom of studs of each wall panel with 3 - 2 1/2" Screws. Position so plates are flush with framing.
Toll Free 1-888-658-1658
Note: Plywood is cut slightly smaller than
floor framing. Keep plywood seams tight.
Horizontal Wall Cleats
Narrow Wall Panel
Pilot hole ALL 2x3 Wall
Studs with 1/8" drill bit prior to
screwing. This will make it much
easier to attached together.
Wall Plate
www.outdoorlivingtoday.com
Exploded view of all parts necessary to
complete the Wall Section. Identify all parts
prior to starting.
Door
Header
Door Jambs (2)
Important:
Page 9
Wall
Extendors (2)
Window Wall Panel
Pilot Hole
sales@outdoorlivingtoday.com
first.
Advertisement
