Advertisement
Important - Drill Pilot holes to prevent splitting.
2" Black Screws.
63.
Once door is align in opening, position so there is a 1/2" gap on bottom, and approximately
3/8" on the side. Use a spare piece of siding or shingle to shim door in place at the bottom. Using
2" Black Screws, secure bottom hinge to Door Trim. Hint: Do not attach all the 2" screws until
the door is positioned correctly. You can use a Screw Driver to tighten screws completely so you
don't over tighten.
64.
Locate and identify all Facia pieces: Front & Rear Facia (4) (1/2" x 4" x 50 1/2").
Side Angle Cut Facia (2) (1/2" x 4" x 54 1/8"). In front corner, align side and front Facia together.
Front facia will cap side facia.
Front caps
side facia.
65.
Do a dry run first before securing. Position Front Facia up underneath roof panel and against
rafter ends. Have your helper hold in position. Place angle cut Side Facia underneath roof panel
against Rafter/Facia Nailing Strip. Align so Front Facia caps Side Facia and then attach the front with
6 - 1 1/2" Finishing Nails. Attach side with 5 - 1 1/2" Finishing Nails securing them into the nailing
plate (closer to the top of the side facia board). Attach next piece of Front Facia. Note: With Front
Facia correctly aligned at corners, a small gap may occur at center seam. This will be covered by
Facia Detail Plate in Step 68.
Toll Free 1-888-658-1658
3/8" gap on
side, 1/2" gap
at bottom.
Small gap
may occur.
www.outdoorlivingtoday.com
Page 30
Side Angle
Cut Facia
Rafter/Facia
Nailing Strip
sales@outdoorlivingtoday.com
1/2" gap at
top, 3/8" gap
on side.
Front Facia
Advertisement
