Advertisement
20.
Position Door Jambs flush against narrow and window wall studs and tight to floor. The Jamb is
3 1/2" wide and will sit flush to outside of wall siding. When positioned correctly, secure Jambs using
4 - 2 1/2" Screws.
21.
Position and attach the Door Header to top of Narrow Wall framing and against window wall framing
resting on top of door jambs. Header should sit flush on Door Jambs. Attach with 4 - 2 1/2" Screws. On
window side, screw about 1" from end of header at angle into window wall framing. Pilot hole first.
Top Siding Pc.
22.
Locate an Angled Wall Extendor and Top Siding Piece for Angled Wall Extendor (L/R).
Position top siding on wall extendor and align as shown above. Attach with 3 - 1 1/2" Finishing Nails to
top wall framing. There are left/right top siding pieces. Use rough surface side out.
Place
finished
wall
Note: Bottom siding of wall extendor will overhang and cover siding of side wall.
Toll Free 1-888-658-1658
Jamb flush with
siding butt.
Dado cut on edge.
Top Siding Pc. for Angle Wall can also be
installed after Roof is attached after Step 46.
extendor
on
side
www.outdoorlivingtoday.com
wall
panel
frame.
Page 13
Jamb flush with
top of narrow wall.
Gap on window side.
Angle Pilot
Hole first.
Complete
both
sides
sales@outdoorlivingtoday.com
now.
Advertisement
