Advertisement
44.
Slide 3rd and 4th Filler Shingles up and underneath appropriate shingle rows and follow Steps
41 - 42 to align and attach. On last filler, screws will get covered by Roof Ridge Board (4 1/2" wide).
90° Metal Brackets.
45.
Secure roof panels to walls at both ends by positioning 2 - 90° Metal Brackets on plywood and
outside rafters. Secure with 4 - 1 1/4" Screws per Bracket, complete both sides.
46.
To further secure roof panels from the inside, drill pilot holes on an angle in each panel's Mid
Rafter (3 per Rafter). Using 3 - 2 1/2" Screws, secure rafters to plywood.
Note: from outside if possible, have a helper push roof panel down so plywood sits flush against
rafter while securing.
Note: If Top Siding Pc.
for Angle Wall was not
installed in Step 22 it
can be done now. Attach
with 3 - 1 1/2" Finishing
Nails per piece.
Toll Free 1-888-658-1658
3 - 2 1/2" screws Toe
Nailed in each Mid Rafter.
www.outdoorlivingtoday.com
Page 23
sales@outdoorlivingtoday.com
Advertisement
