Advertisement
Parts Lists:
A - Base, Rear & Front Box Frames (3pcs) 3/4" x 5 1/2" x 23"
B - End Cap Frames
C - Front Trim
D - Side Trims
E - Brackets
F - 1 1/4" Screws
G - 1 1/4" Nails
Flush
Right Angle Cut to Rear
1. On a table position Rear Box and End Cap Frames together so flush at top. Fasten together with
2 - 1 1/4" screws. Place Base Frame tight against Rear and End Cap and flush at bottom. Secure with
2 - 1 1/4" screws. Complete attachment of remaining End Cap Frame. Slide Front Frame between End Caps.
2. Position Front Frame Piece flush with End Cap. Attach both ends with 2 - 1 1/4" screws. Pilot hole Rear
Box Frame near bottom center and secure to Base edge with 1 - 1 1/4" screw. Evenly position Front Trim
(mitre cut on end and dado cut on inside bottom) tight against front frame and nail down with 4 - 1 1/4" nails.
Position Side Trims as per Front and secure with 3 - 1 1/4" nails per side.
Rear
3. On a flat surface, flip Flower Box on it's rear face. Evenly space Brackets and secure through Base Frame
and into the Brackets with 2 - 1 1/4" screws per Bracket. Position completed Flower Box beneath window trim
and screw from inside of box into the center wall stud with 2 - 2" screws. (2" screws supplied with Base Kit.)
Toll Free 1-888-658-1658
Flower Box Assembly Instructions
(2pcs) 3/4" x 5 1/2" x 7" / 8"
(1 pc) 3/4" x 1 1/2" x 26"
(2 pc) 3/4" x 1 1/2" x 8 3/4"
(2 pc) 1 1/2" x 5 1/2" x 5 1/2"
End Cap
Side Trim
Flush
1 1/4" Screw
1 1/4" screws
www.outdoorlivingtoday.com
Outdoor Living Today
Side Trims (D)
End Caps (B)
Rear (A)
Brackets (E)
Front Trim
1 1/4"
Nails
Flush
Page 35
Exploded
View
Front Trim (C)
Base (A)
sales@outdoorlivingtoday.com
1 1/4"
Nails (G)
Front (A)
1 1/4"
Screws (F)
2" screws
Advertisement
