Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for d&b audiotechnik E8
Summary of Contents for d&b audiotechnik E8
- Page 1 Manual 2.2 en...
- Page 2 General information E8 Manual Version: 2.2 en, 05/2021, D2030.EN .02 Copyright © 2021 by d&b audiotechnik GmbH & Co. KG; all rights reserved. Keep this document with the product or in a safe place so that it is available for future reference.
-
Page 3: Table Of Contents
Contents Safety precautions.............. 4 E8 loudspeaker..............5 2.1 E8 Product description..............5 2.2 Connections................5 2.3 Operation..................7 2.3.1 Controller settings..............8 2.3.2 Operation with E-PAC............. 8 2.4 Dispersion characteristics............9 2.5 Technical specifications............11 Manufacturer's Declarations........12 3.1 EU conformity of loudspeakers (CE symbol)......12 3.2 WEEE Declaration (Disposal).......... -
Page 4: Safety Precautions
Generally speaking, a distance of 0.5 m (1.5 ft) from magnetic data carriers (floppy disks, audio and video tapes, bank cards, etc.) is sufficient; a distance of more than 1 m (3 ft) may be necessary with computer and video monitors. d&b E8 Manual 2.2 en... -
Page 5: E8 Loudspeaker
An additional M10 thread in the rear panel can be used to connect a safety wire. The connector panel of the E8 cabinet is recessed and tilted to allow deployment as a stage monitor. With the panel on the right hand side, the cabinet is oriented correctly. - Page 6 2. Push the cover plate towards the connector panel until it fits into place. 3. Fix the cover plate to the connector panel using the four countersunk screws. d&b E8 Manual 2.2 en...
-
Page 7: Operation
In Dual Channel mode, the "X" setup can be selected to drive the cabinet in combination with the E12X subwoofer on the same channel. The setup provides a dedicated correction for the combined frequency response of the system. d&b E8 Manual 2.2 en... -
Page 8: Controller Settings
Frequency response correction of the CPL function 2.3.2 Operation with E-PAC Selecting E8 mode enables the E-PAC to drive up to two E8 loudspeakers. LO IMP mode configures the E-PAC to drive a maximum of four E8 loudspeakers with a 6 dB reduction in input level to the loudspeakers. -
Page 9: Dispersion Characteristics
The following graphs show dispersion angle over frequency of a single cabinet plotted using lines of equal sound pressure (isobars) at –6 dB and –12 dB. Isobar diagram vertical Isobar diagram horizontal Isobar diagram horizontal Isobar diagram vertical d&b E8 Manual 2.2 en... - Page 10 3. Pick the horn at its outer edges and turn it until it snaps into the desired orientation. 4. Relocate and fix the front grill. Rotating the horn ↳ Make sure both quick locks of the front grill are locked correctly before using the loudspeaker. d&b E8 Manual 2.2 en...
-
Page 11: Technical Specifications
126 dB with D12/D20/30D 129 dB with D80 129 dB (SPLmax peak, pink noise test signal with crest factor 4) E8 frequency response, standard and CUT modes. E8 loudspeaker Nominal impedance 16 ohms Power handling capacity (RMS/peak 10 ms) 150/800 W Nominal dispersion angle (hor. -
Page 12: Manufacturer's Declarations
Please dispose of this product according to the respective national regulations or contractual agreements. If there are any further questions concerning the disposal of this product, please contact d&b audiotechnik. WEEE-Reg.-Nr. DE: 13421928 d&b E8 Manual 2.2 en... - Page 13 www.dbaudio.com...
Need help?
Do you have a question about the E8 and is the answer not in the manual?
Questions and answers