Mounting The Inverter - Generac Power Systems PWRcell XVT076A03 Installation Manual

Installing PWRcell Inverter

Mounting the Inverter

CAUTION
Equipment damage. Mount inverter to a strong, stable surface.
Never mount to drywall, plaster, or other non-structural wall
treatments. Failure to mount inverter to a strong, stable surface
could result in equipment or property damage.
1. Verify mounting location adheres to the following
requirements:
•
Location must
requirements listed in Section 3 of this manual.
See Location
information.
•
Inverter must be mounted upright on a vertical wall.
•
Never obstruct intake or exhaust vents.
•
Never allow water to enter intake or exhaust vents.
•
Observe all mounting clearances. See
Inverter Dimensions and Mounting
2. Secure mounting
through mounting holes.
•
Fasteners must adequately secure the 62.7 lbs
(28.4 kg) inverter weight to the wall.
•
Fasteners must be suitable for the mounting
surface.
•
Fasteners must engage at least two studs or other
structural members.
•
Mounting bracket has clearance holes for 1/4 in
fasteners with slots to accommodate different stud
spacings.
3. See 4-3. Insert mounting bracket tabs (A)
Figure
into inverter body slot (B).
12
(000641a)
meet all PWRcell
and Compliance for
PWRcell
Clearances.
bracket mounting
NOTE:
Figure 4-3
inverter
more
Figure 4-3. Mounting Inverter onto Bracket
4. See
Figure
to wall with two fasteners through mounting holes
(C). Holes are spaced at 11 1/4 in from each other.
Use anchors or blocking as needed.
surface
Installation Manual for Generac PWRcell Inverter
is for illustration purposes only.
4-4. Secure the bottom of the inverter
C
Figure 4-4. Mounting Holes
B
A
009991
009992