Additional Tools; Setup Overview - Honeywell NK User Manual

2.2 Additional Tools

Use the following tools to set up and calibrate your Model NK:
• Approximately 50 mm [2 in] of 0.50 mm
• Needle-nose pliers
• Small, standard screwdriver
• Calculator
• Solder and soldering iron (if needed)

2.3 Setup Overview

1. Connect the transducer to the unit (page 5).
2. Turn on the unit (page 8).
3. Set the decimal point location (page 8).
4. Verify the calibration (page 11).
5. Fine tune (page 12).
Setup and Use
2
(or 20 AWG) wire (if needed)
4