Install The Fan - Valor H5 Installation And Operating Instructions Manual

Fan Kits Components
The complete 1195CFK kit contains the following:
•
Fan, motor unit, control wire;
•
Fan control module;
•
Electrical junction box cover w/three-prong
receptacle;
•
Wiring diagram label;
•
12-inch power cord.

Install the fan

This fan (blower) kit can be installed once the electrical
wiring has been roughed into the appliance. Therefore,
if the appliance is already installed without the wiring
it will not be possible to do it without breaking the wall
fi nish. We highly recommend to install this fan kit at the
same time as the appliance.
1.
Install the junction box inside the appliance case.
a) Unpack the fan contents and insure you have
all the items shown above as well as electrical
wiring coming to the appliance.
b) Remove the screw fi xing the rear of the burner
to the manifold bracket as indicated.
Screw
c) Grab the burner and gently pull
up the rear fi rst while pushing
back and unhooking the front
tabs from their retaining lances.
Be careful not to hook the
pilot hood as you pull the
burner up.
d) With great care for all its attachments, remove
the burner module plate (12 screws).
Note: The gasket may adhere and make it
diffi cult to remove.
2
Fan control module
on mounting plate
Electrical
junction
box cover
w/3-prong
receptacle
Wiring diagram
Kit 1195CFK (as supplied)
e) Thread the electrical wire inside the appliance
casing on the left hand side using an approved
clamp for the type of wire used. Do not tighten the
wire clamp just yet to allow for wire adjustment.
Electrical wiring
through the left
hand side of the
appliance case
Approved
Wire Clamp
f) Insert the junction box cover in front of the
appliance case.
12-inch
electrical
cord
Fixing
Fan control
nuts (2) and
module
sheet metal
screw (1)
Fan control
wire (module to
receiver)