Handling Labware Racks Safely; Filling And Emptying The Labware Racks - Agilent Technologies BenchCel Microplate Handler Quick Manual

Handling labware racks safely

Handling labware racks safely
Carrying the labware racks
WAR N IN G
C AU T I O N

Filling and emptying the labware racks

Before you start
WAR N IN G
C AU T I O N
14
The labware racks store the stacks of labware (microplates, tip boxes, and tube racks)
that are processed during a protocol run. This topic describes how to carry labware
racks safely.
Do not hold a rack by the interior edges. The interior edges can have sharp surfaces
that can cause cuts if handled improperly.
A rack that is fully loaded with labware can be heavy. Grasp the rack handle firmly to
prevent the rack from slipping or tilting.
To carry a rack, firmly grasp the rack by the handle as shown in the following figure.
Figure
Carrying a front-load rack
Make sure you understand how to handle the racks safely.
Before you place labware into a rack that is installed on the BenchCel device, the
clamps in the BenchCel stacker head must be closed (extended). If the clamps are
open the stacker grippers will not prevent the stack of labware from dropping.
Before filling or emptying a rack:
•
Position the rack so that the opening is facing you.
•
Determine how the microplates should be oriented in the rack.
G5580A BenchCel Microplate Handler Quick Guide