Table of Contents
Advertisement
Installation must comply with all applicable fire and
health codes in your jurisdiction.
Use appropriate safety equipment during installation and
serving.
n
Do not damage the refrigeration system while installing,
maintaining or servicing the unit.
,
Do not position the air intake vent near steam or heat
exhaust of another appliance.
Location
n
This equipment must be positioned so that the plug is
accessible unless other means for disconnection from the
power supply (e.g., circuit breaker or disconnect switch)
is provided.
n
Adequate means must be provided to limit the movement
of this appliance without depending on or transmitting
stress to the electrical conduit or gas lines.
n
To avoid instability the installation area must be capable
of supporting the combined weight of the equipment
and product. Additionally the equipment must be level
side to side and front to back.
n
This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
n
If a refrigerated base does not have a condensate
evaporator supplied, you must connect the condensate
line to a suitable drain. Otherwise, water will collect on
the floor, causing a potentially hazardous situation.
Part Number: 9291545 REV00 11/20
DANGER
DANGER
Warning
Caution
Warning
Warning
Warning
Warning
Warning
Section 2
Installation
Moisture collecting from improper drainage can create a
slippery surface on the floor and a hazard to employees.
It is the owners responsibility to provide a container or
outlet for drainage.
The location selected for the equipment must meet the
following criteria. If any of these criteria are not met, select
another location.
• Units are intended for indoor use only.
• The location MUST be level, stable and capable of
supporting the weight of the equipment.
• The location MUST be free from and clear of combustible
materials.
• Equipment MUST be level both front to back and side to
side.
• Position the equipment so it will not tip or slide.
• Front casters MUST be locked once positioned.
• Recommended air temperature is 50° - 100°F
(10° - 38°C).
• Proper air supply for ventilation is REQUIRED AND
CRITICAL for safe and efficient operation.
• Do not obstruct the flow of ventilation air. Make sure the
air vents of the equipment are not blocked.
• Do not install the equipment directly over a drain. Steam
rising up out of the drain will adversely affect operation,
air circulation, and damage electrical / electronic
components.
NOTE: This symbol indicates a hot surface that can cause
injury to persons.
This product utilizes Ecomate blowing agent methyl
formate
Warning
n
Notice
7
Hide quick links:
Advertisement
Table of Contents
