Adjusting The Lcd Screen - Sony DCR-TRV17 Operating Instructions (primary manual) Operating Instructions Manual

Recording a picture
Note on the LOCK switch (DCR-TRV17 only)
When you slide the LOCK switch to the right, the POWER switch can no longer be set
to MEMORY accidentally. LOCK switch is set to the left before your camcorder leaves
the factory.
To enable smooth transition
Transition between the last scene you recorded and the next scene is smooth as long as
you do not eject the cassette even if you turn off your camcorder.
However, check the following:
• Do not mix recordings in the SP mode and ones in the LP mode on one tape.
• When you change the battery pack, set the POWER switch to OFF (CHG).
• When you use a tape with cassette memory, however, you can make the transition
smooth even after ejecting the cassette if you use the END SEARCH function (p. 30).
If you leave your camcorder in the standby mode for five minutes while the
cassette is inserted
Your camcorder automatically turns off. This is to save battery power and to prevent
battery and tape wear. To resume the standby mode, set the POWER switch to OFF
(CHG), and to CAMERA again.
When you record in the SP and LP modes on one tape or you record some scenes
in the LP mode
The playback picture may be distorted or the time code may not be written properly
between scenes.
Recording data
The recording date (date/time or various settings when recorded) are not displayed
while recording. However, they are recorded automatically onto tape. To display the
recording date and time, press DATA CODE on the Remote Commander during
playback.

Adjusting the LCD screen

The LCD panel moves about 90 degrees to the viewfinder side and about 180 degrees to
the lens side.
If you turn the LCD panel over so that it faces the other way, the indicator appears
on the LCD screen and in the viewfinder (Mirror mode).
180
90
When closing the LCD panel, set it vertically until it clicks, and swing it into the
camcorder body.
Note
When using the LCD screen except in the mirror mode, the viewfinder automatically
turns off.
22