Heating Recommendations; Cooling Recommendations; Available Accessories - Aquacal WATER SOURCE WS03 Installation Manual

3.4 Heating Recommendations

The following recommendations will reduce the amount of time required to heat a pool. If unsure of
equipment heating capability, review equipment data plate. See "Identifying Model Specifications" on
page 74.
1. Confirm heat pump mode has been set to heating mode.
2. Set the desired temperature (set-point) for the water.
3. Temporarily set the filter pump for continuous operation.
This will allow the Heat Pump the time required to heat the water at start-up.
l
After the water has reached the desired temperature, reset the filter pump to normal operating time-frames.
l
4. Use a pool cover or blanket to reduce heating time.

3.5 Cooling Recommendations

The following recommendations will reduce the amount of time required to cool a pool or cold plunge
application. If unsure of equipment cooling capability, review equipment data plate. See "Identifying
Model Specifications" on page 74.
1. Confirm heat pump mode has been set to cooling mode.
2. Set thermostat to desired water temperature.
3. Temporarily set the filter pump for continuous operation.
This will allow the Heat Pump the time required to cool the water at start-up.
l
After the water has reached the desired temperature, reset the filter pump to normal operating time-frames.
l

3.6 Available Accessories

Accessories may be purchased through an authorized dealer of AquaCal
Bypass Valve Kit (# STK0135)
When high flow rates are outside recommended
l
specifications, please use this kit or an alternative bypass
valve system.
This kit can be used to control excessive water flow
l
through the heat pump. It provides automatic flow
adjustments for most applications.
Call Flex Accessory (# 0030-LEDS)
This accessory will override a circulation pump to provide
l
water to the heat pump when the set temperature is not met.
Page - 76
®
products.