4.2 Weights
NOTE:
Specifications subject to change.
Model Type
Great Big Bopper
4.3 Heating Recommendations
The following recommendations will reduce the amount of time required to heat a pool. If unsure of
equipment heating capability, review equipment data plate. See "Identifying Model Specifications" on
page 43.
1. Confirm heat pump mode has been set to heating mode.
2. Set a desired temperature (set point) for the water.
3. Temporarily set the filter pump for continuous operation.
This will allow the Heat Pump the time required to heat the water at start-up.
l
After the water has reached the desired temperature, reset the filter pump to normal operating time-frames.
l
4. Use a pool cover or blanket to reduce heating time.
4.4 Cooling Recommendations
The following recommendations will reduce the amount of time required to cool a pool or cold plunge
application. If unsure of equipment cooling capability, review equipment data plate. See "Identifying
Model Specifications" on page 43.
1. Confirm heat pump mode has been set to cooling mode.
2. Set thermostat to desired water temperature.
3. Temporarily set the filter pump for continuous operation.
This will allow the Heat Pump the time required to cool the water at start-up.
l
After the water has reached the desired temperature, reset the filter pump to normal operating time-frames.
l
4.5 Available Accessories
Accessories may be purchased through an authorized dealer of AquaCal
Call Flex Accessory (# 0030-LEDS)
This accessory will override a circulation pump to provide
l
water to the heat pump when the set temperature is not met.
Model Number
®
BB500
Install Weight
1540 Pounds
®
products.
Page - 44