Cleaning Equipment After Installation - Aquacal WATER SOURCE WS03 Installation Manual

1.8 Cleaning Equipment After Installation

Installer - If you need to clean the equipment after installation, please use the following guidelines.
WARNING
Possible electric shock hazard - Deactivate power to all electrical devices on the pad when washing heat pump. Do
l
not restore electrical power until equipment is completely dry.
NOTICE
Do not use a pressure cleaner to wash the heat pump. Damage to heat pump components may result. If using a
l
hose-end spray nozzle adjust the spray pattern to low strength only.
Do not spray water directly into the interior of the heat pump; damage to components may result.
l
Do not use chemicals on the display panel.
l
Cleaning
1. Wash cabinet using a low-pressure water hose.
2. While the heat pump is still wet, use an approved cleaning agent to clean the exterior of the heat pump. Do not
use chemicals on the display panel.
3. Use a detergent-dampened cloth to wipe the heat pump's exterior cabinet.
4. Flush all exterior with fresh water using a low-pressure water hose.
5. Dry the cabinet's exterior using a soft cloth.
APPROVED CLEANING AGENTS
Fantastic ®
Formula 409 ®
Cascade ®
All Power Plain Detergent (3% Solution)
Table 4 - Cleaning Agents
•
The trademarks used in approved cleaning agents are the property of their owners and are not related to
AquaCal ® .
Page - 60
Failure to heed the following may result in injury or death.
Failure to heed the following may result in damage to equipment.
•