Brocade Communications Systems 300 Reference Manual page 27

TABLE 1
LED Name
Power Status
System Status
Ethernet
Speed
Ethernet Link
Brocade 300 Hardware Reference Manual
53-1000862-02
Product Name LED Patterns During Normal Operation (Continued)
LED Color Status of Hardware
No light System is off or there is an internal
power supply failure.
Steady green System is on and power supplies are
functioning properly.
No light System is off, boot is not complete,
or boot failed.
Steady green System is on and power supplies are
functioning properly.
Steady amber (for Boot failed, the system is faulty.
more than five
seconds)
Flashing Attention is required. A number of
amber/green variables can cause this status
including a single power supply
failure, a fan failure, or one or more
environmental ranges has exceeded.
No light Port speed is 10 Mbps.
Steady green Port speed is 100 Mbps.
No light There is no link.
Steady amber There is a link.
Flickering amber There is link activity (traffic).
Interpreting LED activity
Recommended Action
Verify the system is on. If the system
is on, the unit is faulty.
Contact Technical Support.
No action required.
Verify the system is on and has
completed booting.
No action required.
Perform the following steps:
Connect a serial cable to the system.
Reboot the system.
Check the failure indicated on the
system console.
Contact Technical Support.
Check the management interface
and the error log for details on the
cause of status.
Contact Technical Support if
required.
No action required.
No action required.
Verify the Ethernet cable is
connected correctly.
No action required.
No action required.
3
17