Omsi Axle - Taylor-Dunn TC-030-60L Operation, Maintenance, And Replacement Parts Manual

Omsi Axle

1. Make sure the ignition switch is in the "OFF"
position.
2. Place the transmission shift lever in the Park or
Neutral position
3. Set the park brake.
4. Place blocks under the front wheels to prevent
vehicle movement.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle.
Failure to use lifting and support devices of rated
load capacity may result in severe bodily injury.
There are three individual sections in the drive axle that
require oil: Left planetary hub, right planetary hub, and
center section. Refer to the Lubrication section for type
and quantity of oil.
5. Park the vehicle on a level surface.
6. Remove one of the oil level plugs on an axle housing.
7. The oil level should be very close to the bottom of
the level plug hole. If the level is low, add through
the fill plug as required.
8. Reinstall the plug.
9. Rotate the wheel hub (right or left) until the fill/level/
drain plug is horizontal to the ground.
10. Remove the plug.
11. The oil level should be very close to the bottom of
the plug. If the level is low, add through the plug as
required.
12. Repeat for the opposite side hub.
13. Reinstall plugs.
Axle Housing Plugs
Maintenance, Service, and Repair
Wheel Hub Plug
Shown in 'level' position
Drive Axle
Page 3