Coolant Temperature; Hour Meter; 10) Oil Pressure; 11) Ignition Switch - Taylor-Dunn TC-030-60L Operation, Maintenance, And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

8) Coolant Temperature

This gauge indicates
temperature of the engine coolant,
not the coolant level. If the coolant
is not at its proper level or mixture,
the gauge indication will not be
accurate.
The pointer moves from the left to the right side of the
gauge as your engine coolant warms up.
Once the engine is warmed up, the typical normal coolant
temperature range is 180 to 210 degrees (F).
Under normal driving conditions, the pointer should stay
in the NORMAL range. It is acceptable for the pointer to
fluctuate within the NORMAL band under normal driving
conditions, and under certain driving conditions such as,
heavy stop and go traffic, driving up hills in hot weather,
or towing hevy loads for the pointer to indicate at the top
of the NORMAL band.
If, under any circumstances, the pointer moves above
the NORMAL range, the engine is overheating and
continued operation may cause engine damage.
• The engine ECU will reduce power if the temperature
exceeds 220 degrees.
• The engine ECU will shut the engine down if the
temperature exceeds 230 degrees.
If your engine coolant overheats:
1. Pull off the road as soon as safely possible.
2. Turn off the engine.
3. Let the engine cool. DO NOT REMOVE COOLANT
SYSTEM FILL CAP UNTIL THE ENGINE IS
COOL.
4. Check the coolant level following the instructions
on checking and adding coolant to your engine.
• If the coolant continues to overheat, have the
coolant system serviced.

9) Hour Meter

The hour meterrecords the number
of hours the vehicle has been in
operation.
the

10) Oil Pressure

This gauge indicates the engine oil
pressure, not the oil level. However,
if your engine's oil level is low, it
could affect the oil pressure.
Typical normal oil pressure range
when engine is hot is 6 to 18 PSI.
With the engine running, the pointer should move into
the NORMAL range. If the pointer drops below the
NORMAL range while the engine is running, you have
lost oil pressure and continued operation will cause severe
engine damage. If the pointer exceeds the NORMAL
range then there may be obstructions in the engine
lubrication system and continued operation will cause
severe engine damage.
If the oil pressure is low, pull to the side of the road and
immediately shut the engine off. Check and add oil as
needed and restart the engine. If the oil pressure is still
low, turn the engine off and have the vehicle towed to a
repair facility.
If the oil pressure is high, pull to the side of the road and
immediately shut the engine off and have the vehicle
towed to your authorized Tiger Tractor repair facility.

11) Ignition Switch

Note: Rotary switch shown. Also
available as a keyed switch.
The ignition switch has 3-positions:
OFF, RUN, START.
Rotating the switch clockwise to the first
position turns the ignition system ON.
Rotating the switch to the START position engages the
engine starter motor. This is a momentary position and
the switch will return the START position when it is
released. Once the switch has been released from the
START position, it must be turned to OFF before it can
be turned back to the START position.
Safety Rules and Operating Instructions
Page 5