Safety Rules And Guidelines; Driver Training Program; Driver Qualifications - Taylor-Dunn TC-030-60L Operation, Maintenance, And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS
SAFETY RULES AND
GUIDELINES
It is the responsibility of the owner of this vehicle to assure
that the operator understands the various controls and
operating characteristics of this vehicle. As well as,
following the safety rules and guidelines outlined in ANSI
B56.9 and listed below.
These vehicles are not designed to be driven
on public roads or highways. They are
available in maximum designed speeds
ranging from 10 to 13 mph. Do not exceed
the maximum designed speed. Exceeding
the maximum designed speed may result
in steering difficulty, motor damage, and/
or loss of control. Do not exceed locally
imposed speed limits. Do not tow this
vehicle at more than 5 mph.
These vehicles are designed for driving on smooth
surfaces in and around facilities such as industrial plants,
nurseries, institutions, motels, mobile home parks, and
resorts. They are not to be driven on public highways.
Vehicle Operational Guidelines, Safety
Refer to
Guidelines
section for important safety information
regarding operating this vehicle.
Read and follow all of the guidelines listed
below. Failure to follow these guidelines
may result in severe bodily injury and/or
property damage.
Before working
on a vehicle:
Make sure the ignition switch is in the "OFF"
position.
Place the transmission shift lever in the
Parkor neutral position.
Set the park brake.
Place blocks under the front wheels to
prevent vehicle movement.
If working on the elctrical system, remove
the negative cable from the battery.

DRIVER TRAINING PROGRAM

Per ANSI B56.9, the owner of this vehicle shall conduct
an Operator Training program for all those who will be
operating this vehicle. The training program shall not be
condensed for those claiming to have previous vehicle
operation experience. Successful completion of the
Operator Training program shall be required for all
personnel who operate this vehicle.
The Operator Training program shall include the
following:
•
Operation of this vehicle under circumstances
normally associated with your particular environment.
•
Emphasis on the safety of cargo and personnel.
•
All safety rules contained within this manual.
•
Proper operation of all vehicle controls.
•
A vehicle operation and driving test.

Driver Qualifications.

Only those who have successfully completed the
Operator Training program are authorized to drive this
vehicle. Operators must possess the visual, auditory,
physical, and mental ability to safely operate this vehicle
as specified in the American National Standards Institute
Controlled Personnel and Burden Carriers ANSI B56.9.
The following are minimum requirements necessary to
qualify as an operator of this vehicle:
•
Demonstrate a working knowledge of each control.
•
Understand all safety rules and guidelines as
presented in this manual.
•
Know how to properly load and unload cargo.
•
Know how to properly park this vehicle.
•
Recognize an improperly maintained vehicle.
•
Demonstrate ability to handle this vehicle in all
conditions.
Safety Rules and Operating Instructions
Page 3