Sleeve Seal Replacement - Taylor-Dunn TC-030-60L Operation, Maintenance, And Replacement Parts Manual

Sleeve Seal Replacement

1 Loosen the two locking nuts on the mounting bolts and
remove the sleeve/bolt subassembly (9) from the brake.
Remove sleeve seals (14).
2 Insert new sleeve seals (14) between the Torque Plates
(5 & 7) and align with the sleeve bores.
NOTE: PRIOR TO THE INSTALLATION OF THE
MOUNTING BOLT & SLEEVE ASSEMBLY, IT IS
RECOMMENDED THAT "ALPHA 2000" GREASE
(ANTI-SEIZE & LUBRICATING COMPOUND)
MANUFACTURED BY CHEMTOOL, BE APPLIED
TO THE SLEEVES AND THE BORES OF THE
TORQUE PLATES.
3 Insert Sleeve/Bolt sub-assembly (9) through the front
torque plate (5), sleeve seal (14), and back torque plate
(7).
4 Mount brake per paragraph 3.2 and adjust per Adjustment
Procedure on the preceding page.
ITEM # DESCRIPTION
1 LEVER
2 BOLT1/2-20X5.5
3 BOOT
4 CAM
5 TORQUE PLATE FRONT
6 LIMNG & CARRRIER ASSY
7 TORQUE PLATE REAR
8 BALL/RETAINER SUB ASSY
9 SLEEVE OR SLEEVE/BOLT SUB ASSY
10 SPRING FLAT
11 GARLOCK THRUST BEARING
12 1/2-2OHEXNUT
13 1/2-2OJAIVINUT
14 SEAL SLEEVE
15 IDSEAL
16 WASHER HARDENED
17 WASHER
Maintenance, Service, and Repair
QTY.
1
1
1
2
1
2
1
1
2
1
1
1
1
2
1
1
1
Brake Service
Page 11