Specifications - Makita M6200 Instruction Manual

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Switch trigger
2-2. Counterclockwise
2-3. Clockwise

SPECIFICATIONS

Capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model M6200
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model M6201
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
4-1. Leaf spring
4-2. Rear handle
4-3. Boss
5-1. Rear handle
5-2. Screw
Model
Steel
Wood
No load speed
Overall length
Net weight
Safety class
noise level determined
) : 84 dB (A)
pA
) : 95 dB (A)
WA
) : 82 dB (A)
pA
) : 93 dB (A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h,D
2
M6200
13 mm
36 mm
0 - 700 min
267 mm
2.7 kg
ENE032-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-2
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
ENG905-1
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Drill
Model No./ Type: M6200, M6201
Conforms to the following European Directives:
2006/42/EC
ENG900-1
They are manufactured in accordance with the following
standard or standardized documents:
sum)
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3
6-1. Drill chuck
8-1. Limit mark
9-1. Brush holder cap
9-2. Screwdriver
M6201
13 mm
36 mm
-1
600 min
267 mm
2.7 kg
/II
-1
ENG901-1
ENH101-18