Honeywell NOTIFIER PSE-6 Instruction Manual page 30

Power supply expanders

Table of Contents

LED Indicators

Output Circuit Status LEDs (red)

Output inactive

Output active

Output Circuit Trouble LEDs (yellow)

No Fault

Fault Condition (Normal/Standby Mode):

Wire Supervision

Class A or B Open circuit

1 short blink (250ms)

Fault Condition (Normal/Standby Mode):

Wire Supervision

Class A or B Short Circuit

2 short blinks (250ms)

Fault Condition:

Aux Power Supervision

Class A Open circuit

(ZNAC-PS Circuit #1 and #2 only)

3 short blinks (250ms)

Fault Condition:

Power limit condition (individual ckt overload)

4 short blinks per individual circuit (250ms)

Fault Condition:

Power limit condition (panel overload)

4 short blinks on all output circuits (250ms)

Operating Mode Fault:

Power Supply not in Normal Operating mode

1 short blink from right to left across all output

circuits.

Set positions 9 and 10 on S1 to the ON

position.

LED is OFF

LED is ON constant

LED is OFF

Repeating LED blink pattern (non-diagnostic mode and diagnostic mode)