Blade Replacement; Lower Blade; Upper Blade - Cembre B35M-TC025 Operation And Maintenance Manual

4.2) Storage
When not in use, the tool should be stored and transported in the plastic case to prevent damage.
The case is suitable for storing the tool and accessories.
Plastic case: VAL P22, size 465x315x135 mm (18.3x12.4x5.3 inches) weighs 1,5 kg (3.3 lbs).

5. BLADE REPLACEMENT

After extended use, the blades may loose their cutting edge.
Replace the blades as follows:

5.1) Lower blade

– Release latch (66), and open the tool head.
– Operate the tool to advance the lower blade (26) until grub screw (27) is visible on theram (16).
– Using a fl at blade screwdriver remove the grub screw (27) and release the lower blade (26).
– Insert the new blade and fi t the grub screw (27).
Warning: before closing the tool head, release the oil pressure and retract the lower blade,
otherwise the tool head assembly may hit and damage, the lower blade.

5.2) Upper blade

– Release latch (66), and open the tool head.
– Remove the circlip (87) and extract the head pin (86).
– Remove circlip (47) and latch pin (40) to release the latch (66).
Remove latch spring (50) from the spacer (39).
– Using a 10 mm spanner, remove 8 nuts (42), 8 washers (41) and 4 studs (48), releasing the blade
(46).
– Position the new blade in the head assembly, insert 4 studs (48), fi t 8 washers (41) and 8 nuts (42).
Insert the latch spring (50) into the spacer (39). Reassemble the latch (66) and tighten the 8 nuts.
– Fit the head assembly to the head support using the pin (86) and circlip (87).
6. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown contact our Local Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if pos-
sible, attach a copy of the Test Certifi cate supplied by Cembre together with the tool or, if no
other references are available, indicate the approximate purchase date and the tool serial number.
7
(Ref. to Fig. 4 and 5, page 33)
ENGLISH