Table of Contents
Advertisement
TABLE 3 - TABLEAU 3 - TABELLE 3 - TABLA 3 - TAVOLA 3
4.2) Storage
When not in use, the tool should be stored and transported in the metal case, to prevent
damage. Metal case: VAL B-TC095, size 565x410x132 mm (22.2x16.1x5.2 in.), weight
6,7 kg (14.7 lbs).
4.3) Head rotation
For ease of operation, the tool head can rotate through 335°, allowing the operator to work
in the most comfortable position.
Warning: Do not attempt to turn the head if the hydraulic circuit is pressurised.
5. BLADE REPLACEMENT
After extended use, the blades may lose their cutting edge.
Replace the blades as follows:
– Operate the motor so to advance the ram until the pins (38) of the blades are visible
(Fig. 2a).
– Remove circlips (37) and extract the pins (38); to ease the operation it may be
necessary to bend the rubber hand grip (34).
– Remove the nut (84), 2 spacers (92), 2 pins (94) so to extract the central pin (85) and
free the blades.
– Disassemble the blade guide (39) keeping aside the screw (36).
– Assemble the new blades (35) the pivot (85) and pins (94).
– Lock the pin (85) with the nut (84) washer (93) and spacer.
– Assemble the 2 pins (38) and stopping them with circlips (37).
– Assemble the blade guide (39).
– At the end of the operation, press on the release lever to withdraw the ram.
33
6
(Ref. to Fig. 3)
(Ref. to Fig. 2)
ENGLISH
Advertisement
Table of Contents
