Head Rotation - Cembre B35M-TC025 Operation And Maintenance Manual

The tool can be held in one hand while positioning the conductor with the other.
The part reference includes the following:
– Basic tool complete with battery.
– Spare battery.
– Battery charger (model depends on the tool version).
– Plastic carrying case VAL P22.
2. INSTRUCTIONS FOR USE
2.1) Setting
With the tool in the rest position, proceed as follows:
Insert the conductor between the blades at the desired cutting point.
For a running conductor, release the latch (66) and open the tool head.
O
PENING THE UPPER BLADE MUST BE DONE ONLY WHEN THE TOOL IS IN REST POSITION
(26)
BLADE COMPLETELY RETRACTED
With the conductor on the lower blade (26), close the tool head and fully secure the latch (66).
Before commencing the cutting operation ensure that the latch (66) is fully secured: partial
closure may damage the tool head.
2.2) Blade advancement
Grip the tool fi rmly and comfortably and press the operating button (4) to activate the motor-pump
group for the advancement of the lower blade (26). To halt the advancement, release the operating
button (4) and the motor will cut out.
2.3) Cutting
By keeping operating button (4) pressed, the motor continues to operate: the ram will gradually
move the lower blade to cut through the conductor.
The motor will continue to operate after the maximum pressure relief valve has activated. No further
cutting force is applied, the oil is bypassed and returned to the reservoir.
2.4) Blade retraction
Press the pressure release button (9), the ram will retract and open the blades.

2.5) Head rotation

For ease of operation the tool head can rotate through 180°, allowing the operator to work in the
most comfortable position.
Warning: do not attempt to rotate the head when the hydraulic circuit is pressurised.
5
(Ref. to Fig. 1 page 3)
).
ENGLISH
(
LOWER