Typical Setup For A Test Cell Without Guard Ring - Omicron Lab SPECTANO 100 Quick Start Manual

Hide thumbs Also See for SPECTANO 100:

Table of Contents

SPECTANO 100 Quick Start Guide

7.4.2

Typical setup for a test cell without guard ring

To connect SPECTANO 100 to a test cell with guard ring:

1. Ground SPECTANO 100 according to the safety rules (see 2.2 "Five safety

rules" on page 5).

2. Connect the standard triaxial cable according to the color code to the

SPECTANO 100 OUTPUT and INPUT connectors:

• Red-labeled cable to the OUTPUT connector

• Blue-labeled cable to the INPUT connector

3. Depending on the test cell connection (BNC or 4 mm plug), connect one of

the adapter cables described earlier in this chapter with the corresponding

color code to the standard triaxial cable:

• Red-labeled adapter cable to the red marked standard cable

• Blue-labeled adapter cable to the blue marked standard cable

4. Connect the adapter cables to the test cell with guard ring according to the

schematic diagram.

Note: If you are using the triaxial-to-4 mm plug adapter cable, be aware that the

inner shield (guard) and the outer shield (ground) are not connected.

For more information and example connections to different types of test cells,

see "Appendix" in the SPECTANO 100 User Manual.

DANGER

Death or severe injury caused by high voltage or current

► Do not touch the OUTPUT connector when the red LED is on or blinks.

► Always ensure that no dangerous voltages are present at any touchable

part of the device, test cell or sample.

► Do not touch the output if the guard (inner shield of the triaxial connection)

is identical with the ground (outer shield of the triaxial connection).

Table of Contents