Command Start - RCNTEC RPCM Series User Manual

6.11. Command start

6.11.1. General information
It is used to run additional procedures.
Help ask:
start ?
Output of information about the command:
RPCM Commands description:
start firmware
update
start update
start configuration
restore
Type 'help' to get suggestions
6.11.2. Command start update
It is used to start the system update process after downloading the update file.
Help ask:
start update?
The return is:
We are not ready to start update, software update file should be uploaded and verified...
For information on the operation of this construction, refer to section 4.7. Updating the RPCM
software.
6.11.3. Command start firmware update
Used to update the firmware.
The firmware have to updated after installing the software.
The procedure requires a separate manual start.
Use:
start firmware update
For more details, please refer to the section: "4.7. Updating the RPCM software".
- start firmware update procedure
- start software update procedure
(software update file should already be uploaded)
- start configuration restoration procedure
(configuration file should already be uploaded)
6. Command Reference of RPCM CLI
319