General Description Of The Command System - RCNTEC RPCM Series User Manual

6.1. General Description of the Command System

The basis of the command line interface is command.
If necessary, the command can be successively supplemented with keys (one or more).
At the end of the command line, specify the parameter, which specifies the scope or object of the
application.
WARNING! The CLI command line interface uses the function of autocompletion of parameters,
including during deletion. Because it is strongly recommended to avoid similar names, for exam-
ple, user accounts, names of devices for automation, e-mail addresses and so on.
To avoid erroneous operation of commands due to auto-completion parameters:
 do not use similar names of devices, users, and so on;
 do not work with RPCM in poor communication conditions;
 it is also recommended to always monitor the state of the system using the show all com-
mand sets;
 carefully read the obsessed commands before pressing the "Enter" key.
Limit conventions:
 Voltage — min. value10V, max. value 58V;
 Time indicators — min. value 0 seconds, max. value 65535 seconds.
Note: The specified minimums and maximums are the maximum allowable parameters that can be used in the RPCM Smart
PDU settings. Please note that the functionality of the RPCM Smart PDU guarantee stable work only if the limits specified in
the technical specification for the model you are using are met. The performance of the equipment connected to the RPCM
Smart PDU is determined by the technical specifications of such equipment (please refer to the documentation of the man-
ufacturer of the connected equipment to find out the maximum allowable values).
6. Command Reference of RPCM CLI
226