6. Command Reference of RPCM CLI
6. Command Reference of RPCM CLI
A brief description of the section:
6.1. General Description of the Command System
6.2. Command: help
6.3. Commands: exit and quit — these are two analogous commands that serve to properly
conclude an SSH session.
6.4. Commands: add and delete — these commands are used to add and delete configurations
for SNMP, SMTP, automation, users etc.
6.5. Command: restart — for "Power Cycling" of Connected Devices
6.6. Command: show — Obtaining Information about the Status of RPCM and Connected
Equipment
6.7. Command: show all command allows to display different parameters for many objects at
once.
6.8. Command: set command — it is the main command to set the required values within the
RPCM work setup.
6.9. Command: set output —it serves to control the outlet by setting various parameters.
6.10. Command: automation device — it serves to to configure the monitoring and control sys-
tem (reboot) of the connected devices.
6.11. Command: start — it is used to run additional procedures.
6.12. Command: whoami — displays the name of the active user account in which the system is
running.
6.13. Command: ping — it is used to diagnose network connections.
6.14. Command: cancel — it is use to cancel the update.
225