Installation
Installing modules
3.7.6
Installing an EVM module
Installation Procedures
Step
1.
Turn off the power supply.
2.
Remove the system's cover
3.
Attach the separator provided with the module to the MB.
4.
Attach the module to the MB's pin Connector and to the separator.
5.
Reassemble the entire set.
6.
"Performing a visual inspection" on page 3-35.
7.
Turn on the power supply.
8.
Configure the required data (see Service Manual).
Assembly Diagram
Figure 3-8
Installing an EVM module HiPath 1120
3-22
Procedure
HiPath1120, Installation Guide