Installation
Installing the power supply
3.8
Installing the power supply
Introduction
Before connecting the power supply to the system, see Service Manual.
3.8.1
On the HiPath 1120
Installation Procedures
Step
1.
Check network voltage
2.
If the voltage is within the power supply's voltage range, connect the power supply.
3.
"Performing a visual inspection" on page 3-35
4.
Configure the required data (see Service Manual).
Warning
!
Use the cable of the power supply to turn system power on or off.
Figure 3-13
Installing a power supply on the HiPath 1120
3-28
Procedure
HiPath1120, Installation Guide