Fips Support; Public And Private Key Management; The Firmwaredownload Command - Brocade Communications Systems 53-1001763-02 Administrator's Manual

FIPS Support

Federal information processing standards (FIPS) specify the security standards needed to satisfy a
cryptographic module utilized within a security system for protecting sensitive information in the
computer and telecommunication systems. For more information about FIPS, refer to
"Configuring Security
The v6.4.0 firmware is digitally signed using the OpenSSL utility to provide FIPS support.To use the
digitally signed software, you must configure the switch to enable Signed Firmwaredownload. If it is
not enabled then the firmware download process ignores the firmware signature and work as
before.
If Signed Firmwaredownload is enabled, and if the validation succeeds, the firmware download
process proceeds normally. If the firmware is not signed or if the signature validation fails,
firmwareDownload fails.
To enable or disable FIPS, refer to

Public and Private Key Management

For signed firmware, Brocade uses RSA with 1024-bit length key pairs, a private key and a public
key. The private key is used to sign the firmware files when the firmware is generated. The public
key is packaged in an RPM-package as part of the firmware, and is downloaded to the switch. After
it is downloaded, it can be used to validate the firmware to be downloaded next time when you run

the firmwareDownload command.

The public key file on the switch contains only one public key. It is only able to validate firmware
signed using one corresponding private key. If the private key changes in future releases, you need
to change the public key on the switch by one of the following methods:
•
•
NOTE
If FIPS is enabled, all logins should be done through SSH or direct serial and the transfer protocol
should be SCP.
Updating the firmwarekey
1. Log in to the switch as admin.
2. Type the firmwareKeyUpdate command and respond to the prompts.
The firmwareDownload Command
As mentioned previously, the public key file will need to be packaged, installed, and run on your
switch before downloading a signed firmware.
Fabric OS Administrator's Guide
53-1001763-02
Policies".
By using the firmwareDownload command. When a new firmware is downloaded,
firmwareDownload always replaces the public key file on the switch with what is in the new
firmware. This allows you to have planned firmware key changes.
By using the firmwareKeyUpdate command. This command retrieves a specified public key file
from a specific server location and replaces the one on the switch. So for easy access, the
information regarding firmware versions and their corresponding public key files should be
documented in the release notes or stored in a known location in the Brocade website. This
command allows the customer to handle unplanned firmware key changes.
Chapter 7, "Configuring Security

FIPS Support

Chapter 7,
Policies".
9
201