Figure 74 Example Of Setting Up Speed Lsan Tag - Brocade Communications Systems 53-1001763-02 Administrator's Manual

FIGURE 74
Rules for LSAN tagging
Note the following rules for configuring LSAN tags:
•
•
•
•
•
•
Configuring an Enforce LSAN tag
1. Log in to the FC router as admin.
2. Enter the following command to disable the FC router:
3. Enter the following command to create an Enforce LSAN tag:
Fabric OS Administrator's Guide
53-1001763-02
D1
Edge fabric 1
FC router 1
Example of setting up Speed LSAN tag
You configure the tags on the FC router, and not on the edge switches. If Virtual Fabrics are
enabled, you configure the tags on the base switch on which the EX_ and VEX_Ports are
located. You then have to ensure that the LSAN zones in the edge fabrics incorporate the tags
correctly.
The LSAN tags are configured per FC router, not per fabric. If the backbone fabric has multiple
FC routers, it is recommended that you configure the LSAN tags on all of the FC routers.
The FC router must be disabled before you configure the Enforce tag. Configuring the Speed
tag does not require that the FC router be disabled; however, after configuring the Speed tag,
you must toggle the host or target port to trigger the fast import process.
The tag is from 1 to 8 alphanumeric characters.
You can configure only one Speed tag on an FC router, and up to 8 Enforce tags on an FC
router. The maximum number of tags (Enforce and Speed) on an FC router is 8.
Up to 500 Speed LSANs are supported.
switchdisable
fcrlsan --add -enforce tagname
where tagname is the name of the LSAN tag you want to create.
LSAN zone configuration
H1
Edge fabric 2
FC router 2
21
D2
Edge fabric 3
= LSAN
483