Windshield Mount - Minolta MNCD60 User Manual

1.5 Windshield Mount

1. Insert the windshield mount as shown in the illustration.
2. Line up the mount's USB plug with the dashcam's
USB port and push in until it lock into place.
3. Once ready to mount to your
windshield, peel off the red sticky
sheet to reveal the sticky pad.
4. Apply the sticky side to the top
center of your windshield. Before
applying to your windshield, make
sure that your windshield is clean
and free from any dirt or debris.
NOTE: The sticky pad will last a long time if applied to the windshield once. If you need to
remove the mount and apply it back into a different position, some of the stickiness will dry
out. It is best to remove the existing sticky tape and apply a new sheet. Included with your
purchase is one extra sticky sheet.
5. Insert the smaller USB plug of the DC power adaptor into the USB port on the
windshield mount as shown in the illustration. Insert the larger power plug end into a free
auxiliary power part in your vehicle's cabin.
5