Toyota LAND CRUISER PRADO Owner's Manual page 170

■ Changing the door unlock function setting (vehicles with a smart entry &
start system)
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the engine switch off.
1
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent
2
unintended triggering of the alarm during the setting change. (P. 96)
When the indicator on the key surface is turned off, press and hold
3
(if equipped) for approximately 5 seconds while pressing
key.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step
Multi-information
display
(Left-hand drive
vehicles)
(Right-hand drive
vehicles)
For vehicles with an alarm: To prevent unintended triggering of the alarm,
unlock the doors using the wireless remote control and open and close a door
once after the settings have been changed. (If a door or the glass hatch is not
opened within 30 seconds after
again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 93)
LC150_OM_OM60R93E_(GE)
3-2. Opening, closing and locking the doors
.)
3
Unlocking function
Holding the driver's door
handle unlocks only
driver's door.
Holding the front passen-
ger's door handle unlocks all
the doors.
Holding either door handle
unlocks all the doors.
is pressed, the doors will be locked
Beep
the
Exterior: Beeps 3 times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
169
or
on the
3