Outbound Call Testing - JDS Uniphase HST-3000 Testing Manual

2.5

Outbound Call Testing

Step Action
1. Dial
2. OK
3. Answer
4. Converse
5. Troubleshoot
Details
Press 1 to Enter Destination Alias. Using the HST-3000 keypad or USB
keypad, enter the Destination Alias for your cell phone and press OK.
For Registering trunks, enter the phone number. For non-registering
trunks, enter a URI as follows: Phone Number@SBC LAN IP Address.
i.e. "3215551234@169.254.20.1".
Notes:
• Use third softkey to toggle between "Keypad:123" for numerical entry
(including ".")
and "Keypad:abc" for text entry (including "@").
• Press "1" seven times to enter "@"
• Press "*" once to enter "."
Press OK again to go off hook and place the call. The HST-3000 will
send an INVITE message to set up the call. Call status is displayed in
the VoIP Phone results screen.
Answer the incoming call on your cell phone. "CONNECTED"
indicates that the call setup was successful.
Confirm that Voice is heard and Voice Quality is good on the HST-3000
and on the Cell Phone.
If "CONNECTED" is not displayed in step 3 or voice is not heard in
step 4, verify that the HST-3000 setup is correct and that your cell phone
is working properly and repeat step 1. If "CONNECTED" is still not
displayed, the test has failed. Contact VoIP Technical Support.
Technical Support tac@jdsu.com
Page 9 of 14
1 866 228-3762