Safety Instructions; Safety Precautions; General Safety During Machsense; R Installation - ABB MACHsense-R Instruction Manual

Document type
Instruction manual for MACHsense-R - MSR1600
3

Safety Instructions

3.1

Safety precautions

These instructions are for all personnel who work on the motor. Personnel performing maintenance on
electrical equipment and installations must be certified. The personnel must be trained in, and familiar
with, the specific maintenance procedures and tests required for rotating electrical machines.
Motor repair and maintenance should be performed following the motors own instruction and safety
manuals. If a variable frequency drive (VFD)
VSD unit's additional safety and instruction manuals.
Before working on any electrical equipment, general electrical safety precautions must be taken into
account, and local regulations must be respected in order to prevent personnel injury. This must be made
according to instructions issued by the security personnel.
Personnel performing maintenance on electrical equipment and installations must be certified. The
personnel must be trained in, and familiar with, the specific maintenance procedures and tests required
for rotating electrical machines. Please read this section before you familiarize yourself with the
MACHsense-R, initial product setup, and registration process.
3.2 General safety during MACHsense-R installation
·
Handle the MACHsense-R carefully and must not be dropped.
·
Use safety shoes with metal toe cap during installation to avoid foot injury.
·
Don't install or perform maintenance on the DAU on a running motor.
·
Make sure that the motor has cooled enough for the installation or maintenance of MACHsense-
R.
·
Make sure to use safe platforms to access the motor. Do not use ladders.
·
When drilling be aware of hot cutting chips. Always wear safety goggles and adequate safety
equipment.
3.3 Electrical safety during MACHsense-R installation
Installing the MACHsense-R will require wiring, so do not try to install when motor or connected drive is
energized. Do not work on the MACHsense-R while VSD unit, motor cable, motor, control cables or
control circuits are energized.
General points to be observed when working around the motor:
·
Do not step on the motor.
·
Be careful since the temperature of the outer casing of the motor will be high during normal
operation and especially after shut-down.
·
Observe rotating parts of the motor and take care during installation.
·
Do not open terminal boxes while energized.
Emergency stop controls must be equipped with restart lockouts. After emergency
stop, a new start command can take effect only after the restart lockout has been
intentionally reset.
1
Also known as variable speed drive (VSD) unit
We reserve all rights in this document and in the information contained therein. Reproduction, use or disclosure to third parties without
express authority is strictly forbidden.
© Copyright 2017 ABB
Document identity
1MZB100400
1
unit is included in the motor setup, please follow also the
PROPRIETARY AND SECRET INFORMATION
Revision Page(s)
A 8(31)