Mounting Of Pads - ABB MACHsense-R Instruction Manual

Document type
Instruction manual for MACHsense-R - MSR1600
7.2

Mounting of pads

Procedure for gluing the pads:
1. All paint must be removed from the surface. Make sure all paint is grinded and the pad is glued
directly on the metal on the motor.
2. Clean the surface with recommended cleaner Loctite 7061.
3. After the cleaner has dried, apply glue Loctite AA326 on the mounting pad. Make sure you put
glue on the side where the threaded mounting hole is not positioned.
4. Spray some activator Loctite SF7649 on the glue and on the surface on the motor. Immediately
attach the pad in correct position and keep steady for 15 minutes.
LOCTITE AA 326 is a yellow to amber, no-mix, medium viscosity (thixotropic) structural
and magnet bonder which is suited to magnet bonding and resistant to temperature up
to +120°C; LOCTITE 326 is activated with LOCTITE SF 7649.
LOCTITE SF 7649 (known as LOCTITE 7649)
Surface Preparation – activator that is solvent-based with low temperature curing. LOCTITE SF 7649 is
designed to promote the curing speed of LOCTITE anaerobic adhesives and sealants without any
significant loss of joint strength.
We reserve all rights in this document and in the information contained therein. Reproduction, use or disclosure to third parties without
express authority is strictly forbidden.
© Copyright 2017 ABB
Mounting pad diagram and technical specs
Document identity
1MZB100400
PROPRIETARY AND SECRET INFORMATION
Revision Page(s)
A 19(31)
Mounting Adaptor
MH130-6A
Adhesive