ABB MACHsense-R Instruction Manual page 25

Document type
Instruction manual for MACHsense-R - MSR1600
9.3 Wiring and Connection of Sensor
The sensor cable has 4 connection pairs as below
·
V (+5V) & Com
supply
·
X – Axis & GND
·
Y – Axis & GND
·
Z – Axis & GND
Locate Connector X54 on the DAU Board and refer following illustration for identifying the MFS
Connections.
Terminal layout in DAU:
The MFS connections must be in the following order
X54 B0 Ch4 - Channel 4 – X - Axis
X54 B0 Ch5 - Channel 5 – Y - Axis
X54 B0 Ch6 - Channel 6 – Z - Axis
Note the polarity
Locate connector X85 on the DAU board and connect the V
connector as indicated in Terminal Layout above.
We reserve all rights in this document and in the information contained therein. Reproduction, use or disclosure to third parties without
express authority is strictly forbidden.
© Copyright 2017 ABB
while connecting the sensor inside DAU.
Document identity
1MZB100400
, identified as +5V & Ground to the Supply
supply
PROPRIETARY AND SECRET INFORMATION
Revision Page(s)
A 25(31)