Table of Contents
Advertisement
18/64
Assembly
Table 8: Symbols used
1
2
SW13
M
= 20Nm
D
SW5
M
= 8Nm
D
PZ2
PH3
gleitmo 585 K
1
2
3
A
B
C
X
Bosch Rexroth AG, Material and information fl ow technology: HQ 2/C-H, HQ 4, 3 842 358 792/2016-12
7.4 Symbols used
Connection with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting into the slot and
tightening. The notch at the head of the bolt indicates the orientation of the T-bolt.
1 = T-bolt insertion position in the slot
2 = T-bolt clamping position in the slot
Tightening torque: 25 Nm
Hex wrench
SW = wrench size ... mm
M
= required tightening torque ... Nm
D
Hex key
SW = wrench size ... mm
M
= required tightening torque ... Nm
D
Screwdrivers for cross-head screws
PZ ... = Pozidriv screwdriver, size ...
PZ ... = Phillips screwdriver, size ...
Lubricate/lubricate with specifi c grease lubricant:
• Fuchs Lubritech gleitmo 585 K: www.fuchs-lubritech.com
The marked parts are not required for the described assembly. Dispose of the
parts or use them for other purposes.
Graphical depiction of mounting steps.
The numbers correspond to the sequence of mounting steps, in accordance with
the instructions in the accompanying text.
Designation of components in graphics.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction, for example, on the back or bottom side of
the product.
Advertisement
Table of Contents
