General Assembly Instructions - Vacmaster VK809PIWR Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

1
6
10
15
16
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY SHAMPOO
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY SHAMPOO VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches. Disconnect the cleaning solution tube from the cleaning solution inlet coupling
on the rear side of the power head (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 7 (Fig. 4).
5. Turn the collection tank upside down and insert the two caster feet into the slots and apply
pressure until they click into place (Fig. 5).
6. Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle
followed by the rear wheel and another washer. Insert the 'R' lock pin into the hole on the end
of the axle to lock into place. Snap the hub cap onto the wheel. Repeat the same steps on the
other end of the axle (Fig. 6).
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer to
page 17 for installation instructions (Fig. 7 & 8).
2
11 12
17
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4
3
8
7
13
18
①
9
5
9
14
19
Detergent Mode
Vacuum Mode
Detergent Mode
Vacuum Mode