Charging Instructions - Heartway Medical Products S26 User Manual

CHARGING INSTRUCTIONS

The Indicator Signal Chart
Mechanical Specification
1. Dimension: 167*74*37 mm.
2. Weight: 490g approx.
3. Charger output: 3-pin connector. (Pin 1-Positive ; Pin 2- Negative ; Pin 3- XXX )
4. AC socket: Standard 2-p oblong
5. AC cable: National wall plug type upon request.
Operation procedures:
1. Attention! Connect charger first to AC power *before* connecting the battery to the charger. Plug into AC mains the "power on" indicator will be on
and the "Status" indicator will be GREEN, then connecting the battery pack to charger.
2. If short circuit at output is found, the "Status" indicator will flash between RED (16ms) and GREEN (496ms).The flash will be there until the
system is reset and the short part is removed.
3. During charging, the "Status" indicator turns on RED. When full, it turns on GREEN
4. To avoid the case of failed battery pack, when the charger stays in pre-charge stage longer than 5 hours, it will stop charging and the "Status"
indicator will be pulsed with a one second to indicate pre-charge error.
5. During charging, user can remove the battery from charger any time as he/she wants. Users also could start to charge the battery at any time. The
charger is able to determine the best cut-in point where the charging process is starting to. In case of problems, please check battery pack and repeat
above steps. If problem persist, please contact your authorized dealer for assistance.
Indicator
Signal
Stand-by
End of charge
Pre-charge state
Charge state
Over current
Over voltage
Over Temperature
Zero voltage pre-charge
State
Short circuit
Power
(Bi-color LEF)
Constant RED
ON
ON
ON
Status
(Dual color LED)
Constant GREEN
Constant RED
Flash between RED and
GREEN every second
Flash between RED and
GREEN
RED:16 ms/ GREEN 496 ms
22