Takex PR-11BE Instruction Manual

Thank you for purchasing our photoelectric beam sensor.
This sensor will provide long and dependable service when properly installed.
Please read this Instruction Manual carefully for correct and effective use.
: This sensor is designed to detect intrusion and to initiate an alarm ; it is not a burglary-preventing device.
TAKEX is not responsible for damage, injury or losses caused by accident, theft, Acts of God ( including inductive
surge by lightning ), abuse, misuse, abnormal usage, faulty installation or improper maintenance.
This beam sensor contains a transmitter receiver and reflector.
As illustrated, an infrared beam, projected by the transmitter, is reflected back to the receiver.
The protection loop is formed along the path from the transmitter to the reflector and back to the receiver.
When this protection loop is interrupted, the receiver will initiate an alarm.
＊This beam sensor requires cable to the sensor unit
end only, and reflects an infra-red light beam off a
reflector unit (supplied). It is suitable for monitoring
entrances, gateways, driveways etc where cabling to
both ends is a problem.
＊This beam sensor can be used internally or
externally, with a maximum range between the
sensor unit and reflector of 15m internally, or 11m
externally.
＊Beam alignment can be adjusted at the sensor side
only.
Instruction Manual
①
：