MasterCraft 055-6767-0 Instruction Manual page 52

52
model no. 055-6767-0 | contact us 1-800-689-9928
• In order to accurately cut crown moulding
for a 90° inside or outside corner, lay the
moulding with its broad back surface flat
on the saw table.
• When setting the bevel and mitre angles
for compound mitres, remember that the
settings are interdependent; changing one
changes the other, as well.
NOTE: The chart below references a compound cut for crown moulding ONLY
WHEN THE ANGLE BETWEEN THE WALLS EQUALS EXACTLY 90°.
KEY
Inside corner - Left side
IL
Inside corner - Right side
IR
Outside corner - Left side
OL
Outside corner - Right side
OR
BEVEL MITRE
SETTING SETTING
33.9° 31.6° Right
33.9° 31.6° Left
33.9° 31.6° Left
33.9° 31.6° Right
Fig. 50
Settings for standard crown
moulding lying flat on compound
mitre saw table
Inside corner
Compound cut crown mouldings
TYPE OF CUT
1. Position top of moulding against fence.
2. Mitre table set at RIGHT 31.6°.
3. LEFT side is finished piece.
1. Position bottom of moulding against fence.
2. Mitre table set at LEFT 31.6°.
3. LEFT side is finished piece.
1. Position bottom of moulding against fence.
2. Mitre table set at LEFT 31.6°.
3. RIGHT side is finished piece.
1. Position top of moulding against fence.
2. Mitre table set at RIGHT 31.6°.
3. RIGHT side is finished piece.
Bevel/Mitre Settings
OR
OL
IR
IL
Outside corner