Screen Layout - Hioki SM7860-01 Instruction Manual

10

1.3 Screen Layout

1.3 Screen Layout
■
Screen P1: Displays output voltage settings.
Output voltage setting
VA: Displays the power supply A circuit voltage setting.
VB: Displays the power supply B circuit voltage setting.
V A ( + ) I R : 1 0 0 0 . 0
V B ( + ) I R :
T E R M I N A L :
O U T 1 : 1 1 1 0 0 0 0 0
O U T 2 : 1 1 1 0 0 0 0 0
O U T 3 : 1 1 1 0 0 0 0 0
O U T 4 : 1 1 1 0 0 0 0 0
L
Key lock display
When the keys are
L
locked, flashes
in reverse video.
Terminal output setting state
The setting is 0 or 1.
From left to right, OUTn row 1 → row 8
0: High-impedance
1: ON
■
Screen P2: Alarm/GP-IB address setting display
Voltage error alarm setting
VA: Power supply A circuit voltage error alarm setting ±(%)
VB: Power supply B circuit voltage error alarm setting ±(%)
V A A L A R M : 1 9
V B A L A R M : 1 9
G P I B A D D R : 1
GP-IB address
L
The LCD screen consists of two display pages. When the SM7860 is turned on,
page 1 is shown.
The scroll keys on the front of the device
used to scroll among the display pages, which can also be selected directly by
sending the " PAG " command from the GP-IB or RS-232C interface.
See: Message List "PAG" (p.30)
2 5 0 . 0
V M A : 1 0 0 0 . 0
V M B :
Monitor voltage value
VMA: Displays the voltage
monitor value for the
power supply A circuit.
VMB: Displays the voltage
monitor value for the
power supply B circuit.
*Fixed-point, zero-suppressed.
(PAGE
Temperature error display
When a temperature error is detected,
"TEMP" flashes in reverse video.
TEMP
TEMP
O K
2 5 0 . 0 O K
Voltage error alarm results
OK: The monitor voltage error
relative to the output volt-
age setting falls within the
normal range relative to
the voltage error alarm
setting.
NG: The monitor voltage error
relative to the output volt-
age setting indicates an
error relative to the voltage
error alarm setting.
Temperature error display
When a temperature error is
detected, "TEMP" flashes in re-
verse video.
TEMP
TEMP
UP▲/ PAGE DOWN▼) are