Corner Wrap Setup; Label Dispense Adjustments - ID Technology 252 Operator / Technical Manual

5.17 Corner Wrap Setup

Corner wrap setup is a two part process that requires setup of the label dispense function
before adjusting the label application process.
The roller arm can be reconfigured to the bottom of the grid if overhead
clearance is an issue.

5.17.1 Label Dispense Adjustments

The angle between the corner wrap vacuum grid and the label as it comes off the peel
edge must be adjusted for a smooth label feed. To adjust the angle, loosen the two
M6x25 screws securing the cylinder pivot. Slide the block to adjust the grid to an
approximate 45 degree angle from the edge of the baseplate. Sliding the block out
increases the angle, whereas sliding the block in will decrease the angle. If the angle is
improperly adjusted, labels may jam during the dispense cycle.
The grid stop position must be adjusted to ensure that the roller fully contacts the label
during application. Locate the #6 phillips head screw directly behind the grid stop rubber
bumper. With a small phillips head screwdriver, loosen the #6 screw. Adjust the bumper
so that the gap between the grid and the roller is approximately 1/16". Tighten the #6
screw to lock the bumper in place.
The label must be fed onto the grid and roller to the proper starting point for application.
This is necessary to ensure that the label is properly attached to the carton. Feed a label
onto the grid and note the position of the leading edge of the label. Loosen the roller
position adjustment screw and position the roller such that the end of the label is at or
slightly past the tangent point on the roller. Tighten the roller position adjustment screw
and verify the label stop position is correct by feeding a label or two.
Operators/Technical Manual
62
Model 252
Label Printer/Applicator