Lifting And Moving - ID Technology 252 Operator / Technical Manual

2. Lifting and Moving

The ID Technology Model 252 has been delivered to you in a shipping carton on a skid
along with any optional stand components purchased. It is recommended that the cartons
not be removed from this pallet until it is in close proximity to the intended installation
area. The first steps towards installation should involve unpacking and assembly of the
stand components. Use caution when assembling the stand as some components are quite
heavy and the stand may be unstable until it is fully assembled.
To prevent back injury, always use a lifting belt and lift with the legs, not
with the back or arms.
Be sure to remove and retain the ¾ hex nut and washers from the
adjustment slide/applicator mounting block of the stand. Be sure they are
easily reachable prior to bringing the applicator to the stand.
Once the stand is assembled and positioned near the point of use, open the carton
containing the Model 252 label printer/applicator. Locate and set aside the package
containing the standard and optional accessories, as well as any additional items that may
have been included with the applicator. Carefully remove the applicator from the carton
by lifting using the u-shape mounting yoke.
To prevent back injury, always use a lifting belt and lift with the legs, not
with the back or arms.
During shipment, the bolts that lock the faceplate to the mounting u-arm
may have loosened, allowing the faceplate to rotate freely. Use caution
when lifting as fingers could be pinched. Support the faceplate when first
lifting until you are sure it is secure.It is recommended that all packing
material and the original shipping
carton be retained in case the unit must be sent back to the factory for
upgrades, refurbishment or repair.
Lifting the applicator by the rollers, applicator assembly, unwind or
rewind spindle is not recommended. This can cause damage or
misalignment that will cause the unit to not operate properly.
Label Printer/Applicator
Operators/Technical Manual
4
Model 252