General Cleaning And Inspection; Bearings - ID Technology 252 Operator / Technical Manual

2. General Cleaning and Inspection

Any maintenance procedure should include a thorough inspection of the complete unit. In
addition to inspecting all of the items listed in the maintenance schedule, check the entire
applicator for loose fasteners, cuts or abrasion on wires or wire carriers, chipped paint that
may lead to corrosion and other indicators of potential problems. Oil and grease drips should
be wiped clean. Dirt and dust should be wiped away or blown off with compressed air.
Debris from products should be removed so they will not become entangled in moving parts.
Use of eye protection is required when using compressed air to clean the unit.

3. Bearings

Ball bearing units are pre-lubricated and sealed by the manufacturer. No maintenance is
necessary and the bearings should only need replacement if they show signs of excessive wear
or are damaged in any way.
Operators/Technical Manual
2
Model 252
Label Printer/Applicator